1. Measure Your Drawer Compartment
Adjust Length X, Width Y, and Height Z to fit IKEA Alex drawers, workbench trays, or hardware bins down to the millimeter.
Pre-configured 180 × 120 × 55 mm open-top birch tray with interlocking half-lap cross dividers and wall mortise slots—ready for Glowforge, xTool, and LightBurn.
Adjust Length X, Width Y, and Height Z to fit IKEA Alex drawers, workbench trays, or hardware bins down to the millimeter.
Set exact plywood caliper thickness (typically 2.9–3.1 mm for 3mm birch) and kerf (0.15 mm) so cross-divider tenons lock snugly.
Export 1:1 mm .SVG or .DXF—the 5 outer tray panels plus Divider-X and Divider-Y nest cleanly with kerf-compensated wall mortise cutouts.
| Laser Machine | Material & Thickness | Measured Kerf | Typical Speed / Power | Joint Fit Guidance |
|---|---|---|---|---|
| Glowforge Basic / Pro (40W CO2) | 3mm Baltic Birch Plywood | 0.15 mm | 170 / Full | Tight press-fit; no glue needed on small boxes |
| Glowforge Basic / Pro (40W CO2) | 3mm Cast Acrylic | 0.16 mm | 165 / Full | Use 0.14 mm for slip-fit solvent welding (Weld-On) |
| xTool S1 / D1 Pro (20W Diode) | 3mm Basswood / Birch | 0.12 mm | 8 mm/s · 100% | Fine rectangular diode spot; air assist mandatory |
| xTool P2 (55W CO2) | 4mm MDF / Draftboard | 0.18 mm | 16 mm/s · 90% | Wipe charred edges before dry-fitting finger joints |
| OMTech K40 / 60W CO2 | 6mm Baltic Plywood | 0.20 mm | 9 mm/s · 75% | Use 2-inch focal lens to minimize tapered kerf walls |
Simple dropped-in dividers rattle loose every time you pull a workshop drawer open. MeshForge generates a true structural cross-lap joint where Divider-X notches downward from the top, Divider-Y notches upward from the bottom, and both dividers lock into kerf-compensated rectangular mortise slots cut directly into all four outer walls.
Once assembled, the dividers stiffen the entire open-top tray against racking so even lightweight 3 mm basswood or birch plywood holds heavy bolts, calipers, and drill bits effortlessly.
Assemble the Bottom, Front, and Left walls first, slide Divider-X and Divider-Y together at their center half-lap notch, engage their tenons into the wall mortise cutouts, then snap Right and Back walls closed.
Yes! Internal mortise cutouts are wound clockwise so our orthogonal kerf offset shrinks the cutout path inward by kerf/2 on every edge—matching the vaporized laser radius to exact tenon thickness.
Check the LASER SHEET readout in the bottom telemetry bar! Keep sheet dimensions under 480 × 275 mm for Glowforge or 498 × 319 mm for xTool S1 to cut all 7 panels in a single pass.